ADTRAN 1000R Series Command Reference Manual page 738

Command Reference Guide
dial-backup redial-delay <seconds>
Use the dial-backup redial-delay command to configure the delay after an unsuccessful call until the call
will be re-tried.
Syntax Description
<seconds>
Default Values
By default, the dial-backup redial-delay period is set to 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Release 8.1
Usage Examples
The following example configures a redial delay of 25 seconds on this endpoint:
(config)#interface atm 1.1
(config-atm 1.1)#dial-backup redial-delay 25
61200510L1-35E
Specifies the delay (in seconds) between attempting to redial a failed backup
attempt (valid range: 10 to 3600).
Command was introduced.
ATM sub-interface was added.
Copyright © 2005 ADTRAN
ATM Sub-Interface Config Command Set
738