Table of Contents
Advertisement
Command Reference Guide
G.703 I
NTERFACE
To activate the G.703 Interface Configuration mode, enter the interface e1 command (and specify the
G.703 port) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface e1 1/2
(config-e1 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
coding [ami | hdb3]
framing [crc4]
on page 666
loopback network [line | payload]
snmp trap link-status
test-pattern [ones | zeros]
ts16
on page 670
61200510L1-35E
C
ONFIGURATION
on page 31
on page 665
on page 667
on page 668
on page 669
Copyright © 2005 ADTRAN
G.703 Interface Configuration Command set
C
OMMAND SET
664
Hide quick links:
Advertisement
Chapters
Table of Contents
