ADTRAN 1000R Series Command Reference Manual page 640

Command Reference Guide
spanning-tree cost <cost value>
Use the spanning-tree cost command to assign a cost to the interface. The cost value is used when
computing the spanning-tree root path. Use the no version of the command to return to the default setting.
Syntax Description
<cost value>
Default Values
By default, the cost value is set to 1000/(link speed in Mbps).
Applicable Platforms
This command applies to the NetVanta 300 and 1000R Series units.
Command History
Release 5.1
Usage Examples
The following example sets the interface to a path cost of 1200:
(config)#interface eth 0/3
(config-eth 0/3)#spanning-tree cost 1200
61200510L1-35E
Specifies a cost value of 1 to 200,000,000.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
640