ADTRAN 1000R Series Command Reference Manual page 262

Command Reference Guide
show monitor session [<session-number> | all]
Use the show monitor session command to display information regarding a specified monitor session or to
display this information for all sessions.
Syntax Description
<session-number>
all
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Usage Examples
The following is a sample from the show monitor session command:
>enable
#show monitor session 1
Monitor Session 1
-----------------
Source Ports:
RX Only: None
TX Only: None
Both: eth 0/2, eth 0/3
Destination Port: eth 0/6
61200510L1-35E
Displays information for a single specific monitor session.
Shows all sessions.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
262