ADTRAN 1000R Series Command Reference Manual page 582

Command Reference Guide
loopback [dte | line | remote]
Use the loopback command to initiate a specified loopback on the interface. Use the no form of this
command to deactivate the loop.
Syntax Description
dte
line
remote
Default Values
No default values necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Usage Examples
The following example activates a line loopback on the DDS interface:
(config)#interface dds 1/1
(config-dds 1/1)#loopback line
61200510L1-35E
Initiates a loop to connect the transmit and receive path through the unit.
Initiates a loop of the DDS circuit toward the network by connecting the transmit
path to the receive path.
Transmits a DDS loop code over the circuit to the remote unit. In response, the
remote unit should initiate a line loopback.
Command was introduced.
Copyright © 2005 ADTRAN
DDS Interface Configuration Command Set
582