ADTRAN 1000R Series Command Reference Manual page 746

Command Reference Guide
hold-queue <queue size> out
Use the hold-queue out command to change the overall size of an interface's WAN output queue.
Syntax Description
<queue size>
Default Values
The default queue size for WFQ is 400. The default queue size for PPP FIFO and Frame Relay
round-robin is 200.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 5.1
Release 8.1
Usage Examples
The following example sets the overall output queue size to 700:
(config)#interface atm 1.1
(config-atm 1.1)#hold-queue 700 out
61200510L1-35E
Specifies the total number of packets the output queue can contain before packets
are dropped. Range: 16 to 1000.
Command was introduced.
ATM sub-interface was added.
Copyright © 2005 ADTRAN
ATM Sub-Interface Config Command Set
746