Dds Interface Configuration Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
DDS I
NTERFACE
To activate the DDS Interface Configuration mode, enter the interface dds command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface dds 1/1
(config-dds 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
clock rate [auto | bps56k | bps64k]
clock source [line | internal]
data-coding scrambled
loopback [dte | line | remote]
remote-loopback on page 583
snmp trap on page 584
snmp trap link-status
61200510L1-35E
C
ONFIGURATION
on page 31
on page 579
on page 580
on page 581
on page 582
on page 585
Copyright © 2005 ADTRAN

DDS Interface Configuration Command Set

C S
OMMAND ET
578