ADTRAN 1000R Series Command Reference Manual page 476

Command Reference Guide
mac address-table static <mac address> vlan <vlan id> interface
<interface>
Use the mac address-table static command to insert a static MAC address entry into the MAC address
table. Use the no form of this command to remove an entry from the table.
Syntax Description
<mac address>
<vlan id>
interface
<interface>
Default Values
By default, there are no static entries configured.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Usage Examples
The following example adds a static MAC address to Ethernet 0/1 on VLAN 4:
(config)#mac address-table static 00:A0:C8:00:00:01 00:12:79:00:00:01 vlan 4 interface ethernet 0/1
61200510L1-35E
Specifies a valid 48-bit MAC address.
Specifies a valid VLAN interface ID (1 to 4094).
Specifies the interface. Type mac address-table static vlan interface ? for a
complete list of valid interfaces.
Specifies a valid slot/port interface ID (e.g., eth 0/1).
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
476