Serial Interface Configuration Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
S I
ERIAL NTERFACE
To activate the Serial Interface Configuration mode, enter the interface serial command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface serial 1/1
(config-ser 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
et-clock-source [rxclock | txclock]
ignore dcd on page 678
invert etclock on page 679
invert rxclock on page 680
invert txclock on page 681
serial-mode [eia530 | v35 | x21]
snmp trap on page 683
snmp trap link-status
61200510L1-35E
C
ONFIGURATION
on page 31
on page 677
on page 682
on page 684
Copyright © 2005 ADTRAN

Serial Interface Configuration Command Set

C S
OMMAND ET
676