ADTRAN 1000R Series Command Reference Manual page 732

Command Reference Guide
dial-backup connect-timeout <seconds>
Use the dial-backup connect-timeout command to specify the number of seconds to wait for a connection
after a call is attempted before trying to call again or dialing a different number. It is recommended this
number be greater than 60.
Syntax Description
<seconds>
Default Values
By default, the dial-backup connect-timeout period is set to 60 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Release 8.1
Usage Examples
The following example configures the AOS to wait 120 seconds before retrying a failed dial-backup call:
(config)#interface atm 1.1
(config-atm 1.1)#dial-backup connect-timeout 120
61200510L1-35E
Specifies the amount of time (in seconds) that the router will wait for a connection
before attempting another call (valid range: 10 to 300).
Command was introduced.
ATM sub-interface was added.
Copyright © 2005 ADTRAN
ATM Sub-Interface Config Command Set
732