Demand Interface Configuration Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
D I
EMAND NTERFACE
To activate the Demand Interface Configuration mode, enter the interface demand command at the
Global Configuration mode prompt. For example:
#configure terminal
(config)#interface demand 1
(config-demand 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
bandwidth <value>
called-number <DNIS number>
caller-number <CLID number>
connect-mode [answer | originate | either]
connect-order [last-successful | round-robin | sequential]
connect-sequence on page 792
connect-sequence attempts <value>
connect-sequence interface-recovery [retry-interval <seconds> | max-retries <value>]
page 795
crypto map <mapname>
demand-hold-queue <packets> timeout <seconds>
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 799
61200510L1-35E
C
ONFIGURATION
on page 31
on page 784
on page 787
on page 788
on page 789
on page 794
on page 796
Copyright © 2005 ADTRAN

Demand Interface Configuration Command Set

C
OMMAND
on page 790
on page 791
on page 798
S
ET
on
782