ADTRAN 1000R Series Command Reference Manual page 199

Adtran network device manual
Hide thumbs Also See for 1000R Series:
Table of Contents

Advertisement

Command Reference Guide
show interfaces shdsl <slot/port>
Use the show interfaces shdsl command to display configuration parameters and current statistics for the
SHDSL interfaces (or a specified interface).
Variations of this command include the following:
show interfaces shdsl <slot/port>
show interfaces shdsl <slot/port> performance-statistics
show interfaces shdsl <slot/port> performance-statistics total-24-hour
show interfaces shdsl <slot/port> performance-statistics <x-y>
show interfaces shdsl <slot/port> version
Syntax Description
<slot/port>
performance statistics
performance-statistics total-24-hourOptional. Displays the current 24-hour totals and the past seven
performance-statistics <x-y>
N
ote: If you wish to display the 24th interval, enter show interface shdsl 1/1
performance-statistics 24-24. Entering show interface shdsl 1/1 performance-statistics
24 results in displaying the 24-hour statistics. Any number other than 24 (between 1 and
96) results in the correct display of the selected interval (e.g., show interface shdsl 1/1
performance-statistics 4 shows the 4th interval).
version
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 4.1
61200510L1-35E
Specifies interface slot and port number to display.
Optional. Displays the current 15-minute interval, the current
24-hour totals, and all 96 stored intervals.
24-hour intervals.
Shows the current 15-minute interval, the current 24-hour totals,
and all intervals from x through y. This command is basically the
same as the performance-statistics command with the added
function of allowing you to specify a particular interval (or range of
intervals) to display rather than displaying all 96.
Optional. Displays current version information (e.g., model and list
number, software version, etc.) for the SHDSL interface.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
199

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF