Frame Relay Sub-Interface Config Command Set - ADTRAN 1000R Series Command Reference Manual

Adtran network device manual
Hide thumbs Also See for 1000R Series:
Table of Contents

Advertisement

Command Reference Guide
F
R
RAME
ELAY
To activate the Frame Relay Sub-Interface Configuration mode, enter the interface frame-relay command
(and specify a sub-interface) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface frame-relay 1.16
(config-fr 1.16)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
description <text>
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dial-backup commands
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password>
page 889
frame-relay commands
ip commands
begin on page 895
lldp receive
on page 916
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive]
mtu <size>
on page 919
spanning-tree commands
61200510L1-35E
S
-I
UB
NTERFACE
on page 31
on page 866
on page 869
on page 870
on page 871
begin on page 873
begin on page 891
on page 917
begin on page 920
Copyright © 2005 ADTRAN

Frame Relay Sub-Interface Config Command Set

C
C
ONFIG
OMMAND
S
ET
on
865

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF