Debug Atm Packet - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide

debug atm packet

Use the debug atm packet command to activate debug messages associated with packets on ATM ports
and virtual circuits. Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use the no
form of this command to disable the debug messages.
Variations of this command include the following:
debug atm packet
debug atm packet interface atm <port id>
debug atm packet interface atm <port id> vcd <vcd number>
debug atm packet vc <VPI/VCI>
Syntax Description
interface atm <port id>
vc <VPI/VCI>
vcd <vcd number>
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 8.1
Usage Examples
The following example activates debug ATM packet debug messages on ATM port 1:
>enable
#debug atm packet interface atm 1
61200510L1-35E
Shows packets on a specific ATM port and on all virtual circuits.
Shows packets on a specific virtual circuit identified by the virtual path
identifier and virtual channel identifier (VPI/VCI).
Shows packets on specific virtual circuit descriptors (VCD).
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
97