ADTRAN 1000R Series Command Reference Manual page 659

Command Reference Guide
switchport trunk allowed vlan [add | all | none | except | remove]
<vlan id list> [all]
Use the switchport trunk allowed vlan command to allow certain VLANs to transmit and receive traffic
on this port when the interface is in trunking mode. To return to defaults, use the no version of this
command.
Syntax Description
add
all
none
except
remove
<vlan id list>
Default Values
By default, all valid VLANs are allowed.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Functional Notes
A VLAN list is a set of VLAN IDs. A valid VLAN ID value must be from 1 to 4094 (inclusive). Each VLAN ID
in a list is delimited by commas, yet a range of IDs may be expressed as a single element by using a
hyphen between endpoints. For example the VLAN ID range 1,2,3,4,6,7,8,9,500 may be more easily
expressed as 1-4,6-9,500. No spaces are allowed in a valid ID range.
Usage Examples
The following example adds VLANs to the previously existing list of VLANs allowed to transmit and receive
on this port:
(config)#interface eth 0/1
(config-eth 0/1)#switchport trunk allowed vlan add 1-4,7-9,500
61200510L1-35E
Adds the specified VLAN IDs to the VLAN trunking allowed list.
Adds all configured VLAN IDs to the VLAN trunking allowed list.
Adds no VLAN IDs to the VLAN trunking allowed list.
Adds all configured VLAN IDs to the VLAN trunking allowed list except those
specified in the <vlan id list>.
Removes VLAN IDs from the VLAN trunking allowed list.
Specifies a list of valid VLAN interface IDs. Refer to Functional Notes, below.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
659