ADTRAN 1000R Series Command Reference Manual page 691

Command Reference Guide
linerate <value>
Use the linerate command to define the line rate for the SHDSL interface (the value includes 8 kbps of
framing overhead). This command is functional only in CO operating mode (see the section
equipment-type [co | cpe]
supported by the SHDSL NIM (1200867L1).
Syntax Description
<value>
Default Values
The default for this command is 2056 kbps.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 3.1
Usage Examples
The following example changes the line rate of the SHDSL interface to 264 kbps:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#linerate 264
61200510L1-35E
on page 688). The first two selections listed in the CLI (72 and 136 kbps) are not
Specifies the line rate in kbps. Range: 200 to 2312 kbps in 64k increments.
Command was introduced.
Copyright © 2005 ADTRAN
SHDSL Interface Configuration Command Set
691