ADTRAN 1000R Series Command Reference Manual page 289

Command Reference Guide
show spanning-tree active [detail]
Use the show spanning-tree active command to display the spanning-tree status on active interfaces only.
Syntax Description
detail
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Usage Examples
The following is an example output using the show spanning-tree active command:
>enable
#show spanning-tree active
Spanning Tree enabled protocol ieee
Root ID Priority 32768
Address 00:a0:c8:00:88:41
We are the root of the spanning tree
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32768
Address 00:a0:c8:00:88:41
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
eth 0/9 Desg FWD 19
eth 0/24 Desg FWD 19
Interface Role
------------------- -------------------
eth 0/2 Desg
eth 0/3 Desg
eth 0/9 Desg
61200510L1-35E
Optional. Displays the spanning-tree protocol status in detail.
Command was introduced.
128.9 P2p
128.24 P2p
Sts
------------------
FWD
FWD
FWD
Copyright © 2005 ADTRAN
Enable Mode Command Set
Cost Prio.Nbr
----------- -------------
19 128.2
19 128.3
19 128.9
Type
---------------
P2p
P2p
P2p
289