ADTRAN 1000R Series Command Reference Manual page 651

Command Reference Guide
switchport mode [access | stack | trunk]
Use the switchport mode command to configure the VLAN membership mode. To reset membership
mode to the default value, use the no version of this command. The stack selection does not apply to the
NetVanta 300 Series units.
Syntax Description
access
stack
trunk
Default Values
By default, switchport mode is set to access.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Functional Notes
Configuring the interface for stack mode (using the switchport mode stack command) enables the switch
to communicate with other switches that it is stacking capable.
Ιf the switch is configured as the stack master (using the (config)#stack master command), it will begin
•
advertising itself as a stack master.
Ιf the switch is configured as the stack member (using the (config)#stack member command), it will
•
begin advertising other stack masters that it knows about.
Stack mode also allows the port to transmit and receive packets on all VLANs that are included in the
VLAN allowed list.
Usage Examples
The following example sets the port to be a trunk port:
(config)#interface eth 0/1
(config-eth 0/1)#switchport mode trunk
61200510L1-35E
Sets port to be a single (non-trunked) port that transmits and receives no tagged
packets.
Sets the port to allow it to communicate with a switch stack.
Sets port to transmit and receive packets on all VLANs included within its VLAN
allowed list.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
651