ADTRAN 1000R Series Command Reference Manual page 683

Command Reference Guide
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series and Total Access 900 Series units.
Command History
Release 1.1
Release 3.1
Release 5.1
Usage Examples
The following example enables SNMP on the serial interface:
(config)#interface serial 1/1
(config-ser 1/1)#snmp trap
61200510L1-35E
Command was introduced.
Command was extended to the SHDSL interface.
Command was expanded to include Ethernet sub-interfaces and Gigabit Ethernet
interfaces.
Copyright © 2005 ADTRAN
Serial Interface Configuration Command Set
683