ADTRAN 1000R Series Command Reference Manual page 765

Command Reference Guide
ip rip receive version [1 | 2]
Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets
received on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
2
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Release 8.1
Functional Notes
Use the ip rip receive version to specify a RIP version that will override the version (in the Router RIP)
configuration.
The AOS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the ATM sub-interface 1.1 to accept only RIP version 2 packets:
(config)#interface atm 1.1
(config-atm 1.1)#ip rip receive version 2
61200510L1-35E
Accepts only received RIP version 1 packets on the interface.
Accepts only received RIP version 2 packets on the interface.
Command was introduced.
ATM sub-interface was added.
Copyright © 2005 ADTRAN
ATM Sub-Interface Config Command Set
765