ADTRAN 1000R Series Command Reference Manual page 610

Command Reference Guide
tdm-group <group number> timeslots <1-31> speed [56 | 64]
Use the tdm-group command to create a group of contiguous channels on this interface to be used during
the cross-connect process. See crypto map <mapname>
Changing tdm-group settings could result in service interruption.
Syntax Description
<group number>
timeslots <1-31>
speed [56 | 64]
Default Values
By default, there are no configured TDM groups.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 5.1
Usage Examples
The following example creates a TDM group (labeled 5) of 10 DS0s at 64 kbps each:
(config)#interface e1 1/1
(config-e1 1/1)#tdm-group 5 timeslots 1-10 speed 64
61200510L1-35E
Identifies the created TDM group (valid range: 1 to 255).
Specifies the channels to be used in the TDM group. This can be entered as a
single number representing one of the 31 E1 channel timeslots or as a contiguous
group of channels. (For example, 1-10 specifies the first 10 channels of the E1.)
Optional. Specifies the individual channel rate on the E1 interface to be 56 kbps or
64 kbps. The default speed is 64 kbps.
Command was introduced.
Copyright © 2005 ADTRAN
E1 Interface Configuration Command Set
on page 1045 for related information.
610