ADTRAN 1000R Series Command Reference Manual page 484

Command Reference Guide
port-auth timeout [quiet-period <seconds> | re-authperiod <seconds> |
tx-period <seconds>]
Use the port-auth timeout command to configure various port authentication timers.
Syntax Description
quiet-period <seconds>
re-authperiod <seconds>
tx-period <seconds>
Default Values
By default, quiet-period is set to 60 seconds, re-authperiod is set to 3600 seconds (1 hour), and
tx-period is set to 30 seconds.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 10.1
Usage Examples
The following example sets the quiet-period to 10 seconds:
(config)#port-auth timeout quiet-period 10
61200510L1-35E
Specifies the amount of time the system will wait before attempting another
authentication once a failure has occurred. Range is 1 to 65,535.
Specifies the amount of time between scheduled re-authentication attempts.
Range is 1 to 4,294,967,295.
Specifies the amount of time the authenticator will wait between identity
requests. Range is 1 to 65,535.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
484