ADTRAN 1000R Series Command Reference Manual page 675

Command Reference Guide
resource pool-member <pool-name> [<cost>]
Use the resource pool-member command to assign the interface to a resource pool, making it a demand
routing resource. Use the no form of this command to return to the default value.
Syntax Description
<pool-name>
<cost>
Default Values
By default, the interface is not assigned to any resource pool.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 11.1
Usage Examples
The following example configures a BRI interface as a member of resource pool MyPool:
(config)#interface modem 1/2
(config-modem 1/2)#resource pool-member MyPool
61200510L1-35E
Specifies the name of the resource pool to which this interface is assigned.
Optional. Specifies the cost of using this resource interface within the specified
pool. In the event of a tie, a resource with a lower cost will be selected first.
Interfaces with the same cost will be selected in alphabetical order by interface
name.
Command was introduced.
Copyright © 2005 ADTRAN
Modem Interface Configuration Command Set
675