ADTRAN 1000R Series Command Reference Manual page 633

Command Reference Guide
port-auth port-control [auto | force-authorized | force-unauthorized]
Use the port-auth port-control command to configure the port-authorization state. Use the no form of
this command to return to the default settings.
Syntax Description
auto
force-authorized
force-unauthorized
Default Values
By default, all ports are forced to an authorized state.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 10.1
Usage Examples
The following example forces Ethernet port 0/1 into an unauthorized state:
(config)#interface ethernet 0/1
(config-eth 0/1)#port-auth port-control force unauthorized
61200510L1-35E
Enables the port-authentication process.
Forces the port into an authorized state.
Forces the port into an unauthorized state.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
633