ADTRAN 1000R Series Command Reference Manual page 564

Command Reference Guide
snr-margin [showtime monitor | training monitor] <margin>
Use the snr-margin command to enable monitoring and set the minimum signal-to-noise ratio (SNR)
during training and showtime. Use the no form of this command to disable monitoring.
Syntax Description
showtime monitor
training monitor
<margin>
Default Values
By default, SNR margin monitoring is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000 Series units.
Command History
Release 8.1
Usage Examples
The following example enables SNR margin monitoring during showtime with a minimum level of 7 dB:
(config)#interface adsl 0/1
(config-adsl 0/1)#snr-margin showtime monitor 7
61200510L1-35E
Enables margin monitoring to retrain the ADSL interface if the specified minimum
margin is violated during showtime.
Enables margin monitoring to retrain the ADSL interface if the specified minimum
margin is violated during training.
Sets the minimum SNR margin in dB. The range is from 1 to 15.
Command was introduced.
Copyright © 2005 ADTRAN
ADSL Interface Config Command Set
564