ADTRAN 1000R Series Command Reference Manual page 649

Command Reference Guide
switchport access vlan <vlan id>
Use the switchport access vlan command to set the port to be a member of the VLAN when in access
mode. To reset the port to be a member of the default VLAN, use the no version of this command.
Syntax Description
<vlan id>
Default Values
By default, this is set to VLAN 1 (the default VLAN).
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Functional Notes
If the port is in the trunk mode, this command will not alter the switchport mode to access. Instead it will
save the value to be applied when the port does switch to access mode. Refer to
| stack | trunk] on page 651
Usage Examples
The following example sets the switchport mode to static access and makes the Ethernet interface 0/1 port
a member of VLAN 2:
(config)#interface eth 0/1
(config-eth 0/1)#switchport mode access
(config-eth 0/1)#switchport access vlan 2
61200510L1-35E
Specifies a valid VLAN interface ID (1 to 4094).
Command was introduced.
for more information.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
switchport mode [access
649