ADTRAN 1000R Series Command Reference Manual page 111

Command Reference Guide
debug gvrp interface <interface> [bpdus | vlans]
Use the debug gvrp interface command to see GARP VLAN Registration Protocol (GVRP) debug
messages related to a particular interface. Debug messages are displayed (real time) on the terminal (or
Telnet) screen. Use the no form of this command to disable the debug messages.
Syntax Description
<interface>
bpdus
vlans
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 8.1
Usage Examples
The following example displays debug messages showing GVRP configuration messages sent and
received on Ethernet interface 0/24:
>enable
#debug gvrp interface ethernet 0/24 bpdus
2000.07.31 23:15:51 GVRP BPDUS.eth 0/24: TX = (Len:2 LeaveAll) (Len:4 JoinIn Vlan:1) (End) ... SENT
2000.07.31 23:15:52 GVRP BPDUS.eth 0/24: RX = (Len:4 Empty Vlan:2) (Len:4 JoinIn Vlan:20) (end)
2000.07.31 23:15:52 GVRP BPDUS.eth 0/24: TX = (Len:4 JoinIn Vlan:1) (End) ... SENT
2000.07.31 23:15:52 GVRP BPDUS.eth 0/24: RX = (Len:4 JoinIn Vlan:20) (end)
2000.07.31 23:16:00 GVRP BPDUS.eth 0/24: RX = (Len:2 LeaveAll) (end)
61200510L1-35E
Activates debug messages for the specified interface. Type debug gvrp
interface ? for a complete list of applicable interfaces.
Displays debug messages showing all GVRP configuration messages sent and
received on the interface.
Displays debug messages showing all GVRP-related VLAN changes occurring on
the interface.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
111