ADTRAN 1000R Series Command Reference Manual page 513

Command Reference Guide
sntp retry-timeout <time>
Use the sntp retry-timeout command to set the amount of time to wait for a response before allowing a
new request.
Syntax Description
<time>
Default Values
By default, the retry timeout is set to 5 seconds.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R and Total Access 900 Series units.
Command History
Release 8.1
Usage Examples
The following example sets the SNTP retry timeout to 10 seconds:
(config)#sntp retry-time 10
61200510L1-35E
Specifies time (in seconds) to wait for a response before retrying. The range is
from 3 to 4,294,967,294.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
513