ADTRAN 1000R Series Command Reference Manual page 572

Command Reference Guide
bonding txnull-timer <seconds>
Use the bonding txnull-timer command to specify the value (in seconds) for the answering endpoint
negotiation timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds>
Default Values
By default, the bonding txnull-timer value is 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Functional Notes
Specifies the length of time the answering endpoint attempts to detect the bonding negotiation pattern from
the originating endpoint before deciding the bonding call has failed. It may be necessary to shorten this
timer if the DTE equipment using the bonding module also has timer constraints for completing
non-bonding parameter negotiation.
Usage Examples
The following example defines a bonding txnull-timer value of 8 seconds:
(config)#interface bri 1/2
(config-bri 1/2)#bonding txnull-timer 8
61200510L1-35E
Specifies the number of seconds the endpoint waits to detect the bonding
negotiation frame pattern from the originating endpoint (after answering a call)
before considering the bonding negotiation a failure.
Command was introduced.
Copyright © 2005 ADTRAN
BRI Interface Configuration Command set
572