ADTRAN 1000R Series Command Reference Manual page 33

Command Reference Guide
end
Use the end command to exit the current configuration mode and enter the Enable Security mode.
When exiting the Global Configuration mode, remember to perform a copy
running-config startup-config to save all configuration changes.
Syntax Description
No subcommands.
Default Values
No defaults necessary for this command.
Applicable Command Modes
Applies to all mode command sets except Basic mode.
Applicable Platforms
Applies to all AOS products.
Command History
Release 1.1
Usage Examples
The following example shows the end command being executed in the T1 Interface Configuration mode:
(config-t1 1/1)#end
#
#- Enable Security mode command prompt
61200510L1-35E
Command was introduced.
Copyright © 2005 ADTRAN
Common Commands
33