ADTRAN 1000R Series Command Reference Manual page 715

Command Reference Guide
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Release 3.1
Release 5.1
Release 8.1
Usage Examples
The following example enables SNMP on the ATM interface:
(config)#interface atm 1
(config-atm 1)#snmp trap
61200510L1-35E
Command was introduced.
Command was extended to the SHDSL interface.
Command was expanded to include Ethernet sub-interfaces and Gigabit Ethernet
interfaces.
Command was expanded to include ATM interfaces.
Copyright © 2005 ADTRAN
ATM Interface Config Command Set
715