ADTRAN 1000R Series Command Reference Manual page 618

Command Reference Guide
channel-group <group#> mode on
Use the channel-group mode on command to add the interface to a channel-group. To remove an
interface from a channel-group, use the no version of this command.
Syntax Description
<group#>
mode on
Default Values
By default, the interface is not part of a channel group.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Functional Notes
There can be up to six channel groups with 2-8 interfaces per group. Dynamic protocols are not yet
supported (only static). A physical interface can be a member of only one channel group.
Usage Examples
The following example adds the Ethernet 0/1 interface to channel group 1:
(config)#interface eth 0/1
(config-eth 0/1)#channel-group 1 mode on
(config-eth 0/1)#
61200510L1-35E
Specifies the channel-group number (1 to 6).
Statically adds the interface to a channel group.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
618