ADTRAN 1000R Series Command Reference Manual page 160

Command Reference Guide
show atm [pvc | traffic] interface atm <interface>
Use the show atm command to display information specific to the asynchronous transfer mode (ATM)
interface.
Variations of this command include the following:
show atm pvc
show atm pvc interfaces atm <interface>
show atm traffic interface atm <interface>
Syntax Description
pvc
traffic
<sub-interface number>
<atm port interface>
<atm vcl interface>
Default Values
No default is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 8.1
Usage Examples
The following is sample output from this command:
>enable
#show atm pvc interface atm 1.1
Name VPI
atm 1.1 0
61200510L1-35E
Displays ATM PVC information.
Displays ATM traffic information.
Displays the ATM PVC information, for the specified sub-interface (x.x) number.
Displays the ATM port traffic information, for the specified ATM port number
(valid range: 1 to 1023).
Displays the ATM VCL traffic information, for the specified ATM VCL number
(valid range: 1 to 1023).
Command was introduced.
Encap
VCI Type SC
200 SNAP N/A
Copyright © 2005 ADTRAN
Peak Avg/Min Burst
Kbps Kbps Cells
0 0 0
Enable Mode Command Set
Status
Active
160