Command Reference Guide
BRI I
NTERFACE
To activate the BRI Interface Configuration mode, enter the interface bri command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface bri 1/2
(config-bri 1/2)#
The BRI interface number in the example above is shown as bri 1/2. This number is based
on the interface's location (slot/port) and could vary depending on the unit's configuration.
Use the do show interfaces command to determine the appropriate interface number.
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
bonding commands
caller-id override [always <number> | if-no-cid <number>]
isdn spid1 <spid> <ldn>
isdn spid2 <spid> <ldn>
isdn switch-type [basic-5ess | basic-dms | basic-net3 | basic-ni]
resource pool-member <pool-name> [<cost>]
61200510L1-35E
C
ONFIGURATION
on page 31
begin on page 567
on page 574
on page 575
Copyright © 2005 ADTRAN
BRI Interface Configuration Command set
C
OMMAND SET
on page 573
on page 576
on page 577
566