ADTRAN 1000R Series Command Reference Manual page 571

Command Reference Guide
bonding txinit-timer <seconds>
Use the bonding txinit-timer command to specify the value (in seconds) for the originating endpoint
negotiation timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds>
Default Values
By default, the bonding txinit-timer value is 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Functional Notes
Specifies the length of time the originating endpoint attempts to detect the bonding negotiation pattern from
the answering endpoint before deciding the bonding call has failed.
Usage Examples
The following example defines a bonding txinit-timer value of 15 seconds:
(config)#interface bri 1/2
(config-bri 1/2)#bonding txinit-timer 15
61200510L1-35E
Specifies the number of seconds the endpoint waits to detect the bonding
negotiation frame pattern from the remote endpoint (when a call is connected)
before considering the bonding negotiation a failure.
Command was introduced.
Copyright © 2005 ADTRAN
BRI Interface Configuration Command set
571