Canon imageRUNNER ADVANCE 8105 Series Service Manual page 820

COPIER > ADJUST > FEED-ADJ
REG-DUP2 Rgst start timing adj: Heavy, 2nd side
Lv.1 Details To adjust the top margin by changing the timing to turn ON the
Registration Motor when feeding the second side of heavy paper.
As the value is incremented by 1, the margin on the left edge of
paper is increased by 0.1 mm.
+: Top margin becomes smaller. (An image moves upward.)
-: Top margin becomes larger. (An image moves downward.)
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -50 to 50
Unit 0.1 mm
Default value -10
LP-FEED1 Cassette pre-rgst arch amount: Plain
Lv.1 Details To adjust the arch amount before registration when feeding plain
paper from the cassette.
As the value is incremented by 1, the pre-registration arch amount
changes by 0.5 mm.
+: Increase
-: Decrease
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -50 to 50
Unit 0.5 mm
Default value 0
LP-FEED2 Casstt pre-rgst arch amount:Heavy/Transp
Lv.1 Details To adjust the arch amount before registration when feeding heavy
paper/transparency from the cassette.
As the value is incremented by 1, the pre-registration arch amount
changes by 0.5 mm.
+: Increase
-: Decrease
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -50 to 50
Unit 0.5 mm
Default value 0
8
Service Mode > COPIER > ADJUST > FEED-ADJ
8
Service Mode > COPIER > ADJUST > FEED-ADJ
COPIER > ADJUST > FEED-ADJ
LP-MULT1 MP Tray pre-rgst arch amount: Plain
Lv.1 Details To adjust the arch amount before registration when feeding plain
paper from the Multi-purpose Tray.
As the value is incremented by 1, the pre-registration arch amount
changes by 0.5 mm.
+: Increase
-: Decrease
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -50 to 50
Unit 0.5 mm
Default value 0
LP-MULT2 MP Tray pre-rgst arch amount:Heavy/Trans
Lv.1 Details To adjust the arch amount before registration when feeding heavy
paper/transparency from the Multi-purpose Tray.
As the value is incremented by 1, the pre-registration arch amount
changes by 0.5 mm.
+: Increase
-: Decrease
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -50 to 50
Unit 0.5 mm
Default value 0
LP-DUP1 Duplex pre-rgst arch amount: Plain
Lv.1 Details To adjust the arch amount before registration when feeding plain
paper in duplex mode.
As the value is incremented by 1, the pre-registration arch amount
changes by 0.5 mm.
+: Increase
-: Decrease
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -50 to 50
Unit 0.5 mm
Default value 0
8-105
8-105