Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1039

20-2) Put the Card Reader External Relay Harness through the Cord Guide, and install the
cover of the guide.
MEMO:
•
When installing it, be sure [A] part does not interfere when opening/closing the Right Rear
Cover 1.
21) Connect the power plug of the host machine to the power outlet.
22) Open the switch cover and turn ON the main power switch.
9
Installation > Card Reader-C1 > Setting After Installation
[A]
F-9-179 F-9-179
9
Installation > Card Reader-C1 > Setting After Installation
Setting After Installation
MEMO:
The number of card (number of department) can be changed if a request arises from a
user. Make this setting before the step 2).
•
Specify the number of cards to be used in service mode (Level 2) > COPIER > OPTION >
FNC-SW > CARD-RNG.
•
To enable the number of sheets, turn OFF/ON the main power switch.
•
After that, go through the procedure from step 1).
1) Enter the card number to be used (1 to 2001).
•
Service Mode > COPIER > FUNCTION > INSTALL > CARD
MEMO:
1000 cards from the inputted number can be used.
2) To enable the number of sheets, turn OFF/ON the main power switch.
3) Insert the registered card, and check that it is in standby.
MEMO:
After setting, if a request arises from a user and changing the number of card (number
of department), make a following setting. In that case, the current counter information
by department will be reset.
•
Execute in service mode > COPIER > FUNCTION > CLEAR > CARD.
•
Specify the number of cards to be used in service mode (Level 2) > COPIER > OPTION >
FNC-SW > CARD-RNG.
• To enable the number of sheets, turn OFF/ON the main power switch.
•
After that, go through the procedure from step 1).
9-77
9-77