Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1150

MEMO:
The HDD has been removed in the figures of the following steps 1) to 9), but it is not
necessary to remove the HDD to perform this procedure.
1) Open the Controller Box, and free the Signal Cable and the Power Supply Cable of the
host machine from the 4 Wire Saddles and the Edge Saddle at the back of the HDD Case
Unit.
x5
9
Installation > [TYPE-6] HDD Data Encryption & Mirroring Kit > Installing the Encryption Board
2) Pull out the cables to the front, and connect the Signal Cable and the Power Supply Cable
to the Encryption Board.
3) Install the Encryption Board.
•
4 Screws (TP; M3x6)
F-9-384
9
Installation > [TYPE-6] HDD Data Encryption & Mirroring Kit > Installing the Encryption Board
x2
x4
9-188
F-9-385
F-9-386
9-188