3) Fit the 2 bosses of the Connector Fixation Screw into the holes of the Conversion
Connector to install, and tighten the screws in the order specified below.
•
2 Screws (P Tightening; M3x8)
CAUTION:
Be sure to firmly hold the Connector Fixation Block when tightening the screws.
•
•
Be sure to follow the correct order to tighten the screws, otherwise the Conversion
Connector may not be connected properly, resulting in poor contact.
x2
9
Installation > [TYPE-8] Option HDD (80GB) + Removable HDD Kit + HDD Mirroring Kit or HDD Data Encryption & Mirroring Kit > Installation Proce
F-9-461
Boss
Hole
F-9-462
9
Installation > [TYPE-8] Option HDD (80GB) + Removable HDD Kit + HDD Mirroring Kit or HDD Data Encryption & Mirroring Kit > Installation Proce
4) Install the HDD Cover.
•
1 Claw
•
1 Screw (TP Round End; M3x6)
CAUTION:
Be sure to use the round end screw included in the Removable HDD Kit as the TP
screw.
Claw
5) Install the HDD Handle.
•
2 Screws (TP Round End; M3x6)
CAUTION:
Be sure to use the round end screw included in the Removable HDD Kit as the TP
screw.
x2
9-232
F-9-463
F-9-464
9-232