Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1054

7) Install the Wireless LAN Support Plate assembled in step 1) to the Main Controller PCB 1.
• 2 Screws (Use the screws removed in step 4).)
•
2 Screws (TP; M3x6) (Included in the Wireless LAN Board)
CAUTION:
When securing the Wireless LAN Support Plate in place using the screws, be careful
not to trap the Fan Cable.
x4
8) Insert the terminal of the Bulkhead Unit to the position shown in the figure.
MEMO:
Check that the terminal is installed properly.
9
Installation > Installation Procedure for Expansion Bus-F1, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Installing the Expan
MEMO:
When installing the IPSec Board, go through the steps 9) through 11). When not
installing it, go on to the step 12).
9) Remove the plate of the IPSec PCB. (The removed plate will not be used.)
• 2 Screws (The removed screws will be used in step 10).)
10)
in the Wireless LAN Board).
F-9-214 F-9-214
• 2 Screws (Use the screws removed in step 9).)
F-9-215 F-9-215
9
Installation > Installation Procedure for Expansion Bus-F1, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Installing the Expan
x2
Install the IPSec PCB removed in step 9) to the Wireless LAN Auxiliary Plate (included
IPSec Security PCB
x2
Wireless LAN
Auxiliary Plate
9-92
F-9-216 F-9-216
F-9-217 F-9-217
9-92