Removing The Pre-Transfer Charging Assembly - Canon imageRUNNER ADVANCE 8105 Series Service Manual

4
Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Assembly
3) Remove the Shield Plate (Left) and pinch the Grid Wire from the left side to clean it on the
left side with lint-free paper moistened with water.
CAUTION:
•
The frame of the Primary Charging Assembly may be distorted, so be careful not to
remove both Left and Right Shield Plates simultaneously.
4) Remove the Shield Plate (Right) and pinch the Grid Wire to clean it on the right side with
lint-free paper moistened with water.
4
Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Assembly

Removing the Pre-transfer Charging Assembly

<Preparation>
1. Open the Inner Cover. (Refer to "Removing the Primary Charging Assembly")
<Procedure>
Note:
•
When removing the Primary Charging Assembly and the Pre-transfer Charging
Assembly, go through the following procedure while the Charging Shutter is open.
• At sleep mode, press the Power Switch on the Control Panel, check that the
machine is in standby condition, turn OFF the Main Power, and then perform
removing.
•
In the case that the condition of the Charging Shutter (open/close) is unknown while
the power of the host machine is OFF, turn ON the power, check that the machine is
in standby condition, turn OFF the Main Power, and then perform removing.
If the above operations are not performed, it may be possible to remove the assembly
while the Charging Shutter is closed, which may damage the drum or the shutter.
F-4-116
1) Turn the Lock Lever in the direction of the arrow to pull out the Pre-transfer Charging
Assembly.
F-4-117
4-106
4-106