Canon imageRUNNER ADVANCE 8105 Series Service Manual page 479

4
Parts Replacement and Clearning > Fixing > Removing the Fixing Roller, Insulating Bush and Thrust Stopper
<Procedure>
1) Place the Fixing Upper Unit as shown in the figure and remove the Fixing Roller Bearing
Retainer.
2) Remove the Fixing Roller Unit.
3) Remove the Thrust Stopper from the Fixing Roller Unit to remove the Fixing Roller.
Bearing
Insulating Bush
Bushing
Spacer
Fixing Roller
Thrust Retainer
Fixing Roller
4
Parts Replacement and Clearning > Fixing > Removing the Fixing Roller, Insulating Bush and Thrust Stopper
F-4-332
Fixing Roller
Thrust Retainer
Gear
Insulating Bush
Bearing
F-4-333
CAUTION: Points to Note at Installation
Be sure to locate the groove of the Fixing Roller Bearing outside the Fixing Upper Unit
to install.
CAUTION: Points to Note when Replacing the Fixing Roller
Do not reuse the once removed Thrust Stopper.
If the Thrust Stopper is reused, it may come off during printing.
4-183
F-4-334
4-183