Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1003

8) After moving the host machine, be sure that there is no toner scattering on the Registration
Assembly and the Pre-transfer Charging Assembly. If there is any toner scattering, wipe off
the toner.
<Registration Assembly Cleaning Procedure>
1) Open the Front Cover.
2) Turn the Fixing Feed Unit Pressure Release Lever in the direction of the arrow to pull
out the Fixing Feed Unit.
3) Wipe the top surface of the Registration Assembly with lint-free paper.
9
Installation > When Relocating the Machine
<Pre-transfer Charging Assembly Cleaning Procedure>
1) Open the Front Cover.
2) Open the Inner Cover.
•
CAUTION:
When removing the Primary Charging Assembly and the Pre-transfer Charging
F-9-86 F-9-86
Assembly, go through the following procedure while the Charging Shutter is open.
•
•
If the above operations are not performed, it may be possible to remove the assembly
while the Charging Shutter is closed, which may damage the drum or the shutter.
F-9-87 F-9-87
9
Installation > When Relocating the Machine
1 Screw (to loosen)
Loosen
At sleep mode, press the Power Switch on the Control Panel, check that the machine
is in standby condition, turn OFF the Main Power, and then perform removing.
In the case that the condition of the Charging Shutter (open/close) is unknown while
the power of the host machine is OFF, turn ON the power, check that the machine is
in standby condition, turn OFF the Main Power, and then perform removing.
9-41
F-9-88 F-9-88
9-41