Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1055

11) Insert the IPSec PCB into the connector on the Expansion PCB to install it.
• 2 Screws (TP; M3x6) (Included in the IPSec Board)
x2
CAUTION:
Install the Main Controller PCB 1 while paying attention not to trap cables.
12) Insert the Main Controller PCB 1 until it stops.
13) Connect the USB Cable and the Control Panel Cable.
14) Insert the terminal of the Antenna for MFP into the terminal of the Main Controller
PCB 1.
9
Installation > Installation Procedure for Expansion Bus-F1, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Installing the Expan
15)
F-9-218 F-9-218
16)
F-9-219 F-9-219
9
Installation > Installation Procedure for Expansion Bus-F1, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Installing the Expan
Install the Side Cover by putting the Antenna for MFP through a hole of the cover.
Close the Right Rear Cover 1.
9-93
HooK
Hole
HooK
F-9-220 F-9-220
9-93