Note On Download Process; Version Upgrade Via Sst - Canon imageRUNNER ADVANCE 8105 Series Service Manual

■

Note on Download Process

Warning: Never turn OFF the power during the download / writing process.
Turning off the power during the download / writing process may cause a failure of
machine start-up at power-on.
If this occurs, start the machine in Safe mode (by pressing 2 and 8 keys simultaneously
on the numeric keypad).
When the machine is successfully started in Safe mode, execute formatting of
BOOTDEV partition, retry downloading the system software.
Note: Normal mode is recommended when downloading the system software.
The system software can be downloaded either in Normal or Safe mode. However,
some of the version information cannot be obtained when downloading the system
software in Safe mode. Thus, the SST version is unconditionally overridden in Safe
mode. In addition, the system software version may be downgraded inadvertently
because no message is shown on the control panel during the download process in
Safe mode. It will take extended time since existing versions are also overridden.
Warning: Error code E753-0001
The error code, E753-0001, is triggered when any error occurs during the writing
process of the system software downloaded via SST or the USB memory storage
device storage device. This error code is also shown when the system software is
downloaded for the option not attached to the host machine. If the error is triggered by
the software for the unattached option, turn OFF / ON the power for recovery. Listed
below are the codes that may be actually shown during the download process. If any of
these is shown for the unattached option, turn OFF / ON the power.
(Please see Trouble Shooting for details)
Name of system software
FIN_D1 Staple Finisher-D1/Booklet Finisher-D1/Paper Folding Unit-H1/
Document Insertion Unit-K1/Inner Booklet Trimmer-A1
PIU_B1 Professional Puncher Integration Unit-B1
6
Troubleshooting > Version upgrade > Version Upgrade via SST > Overview
Option
6
Troubleshooting > Version upgrade > Version Upgrade via SST > Overview

Version Upgrade via SST

■
Overview
The system software can be downloaded either of the two modes below via SST.
•
Assist mode(recommended)
•
Single mode
Assist mode provides the following features.
• Attached option types are automatically recognized.
•
The new versions of the system software for attached option types are automatically
searched.
The set of system software with interactive behavior confirmed is automatically
•
downloaded.
•
The accessories attached to the host machine are automatically recognized to download
the system software for each accessory.
This machine holds a number of system software components that mutually interacts
during operation. Behaviors of such system software should be confirmed when these are
downloaded as the set. Thus, Assist mode is basically recommended to download the system
software for this machine.
Use Single mode only when any of the following conditions is met.
•
When downloading some the system software components, i.e. DCON, RCON or options.
•
When reloading the system software after HDD is formatted
MEMO:
Use Single mode only when any of the following conditions is met.
•
When downloading some the system software components, i.e. DCON, RCON or options.
•
When reloading the system software after HDD is formatted
T-6-16 T-6-16
6-36
6-36