5) Remove the Leaf Spring from the removed rail in the order of the arrows in the figure
below. (The removed Leaf Spring will not be used.)
•
2 Bosses
•
2 Arms
Boss
Boss
Turn over
6) Install the HDD Lock Pin and the HDD Lock Spring to the removed rail.
7) Return the rail to its original position.
•
2 Bosses
•
2 Screws (Use the screws removed in step 4).)
Hole
Hole
x2
Boss
9
Installation > [TYPE-8] Option HDD (80GB) + Removable HDD Kit + HDD Mirroring Kit or HDD Data Encryption & Mirroring Kit > Installation Proce
Arm
Boss
F-9-470
9
Installation > [TYPE-8] Option HDD (80GB) + Removable HDD Kit + HDD Mirroring Kit or HDD Data Encryption & Mirroring Kit > Installation Proce
8) Insert the HDD Drawer Unit into the hole on the HDD Case Unit to install it.
•
2 Screws (TP Round End; M3x6)
9) Close the Edge Saddle.
x2
F-9-469
■
Installing the Mirroring Board or Encryption Board and HDD
Case Unit
MEMO:
The following shows combination of the HDD and the Mirroring Board or Encryption
Board.
•
Connect "CH A" to Slot.1 (The original HDD)
•
Connect "CH B" to Slot.2 (The new HDD)
Edge Saddle
F-9-471
Power Supply Cable
B
Signal Cable
C H
A
Signal Cable
C H
Power Supply Cable
F-9-472
9-234
9-234