2) Install the Conversion Connector.
CAUTION:
Be sure that there is no gap between the HDD Connector and the Conversion
Connector.
9
Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Assembling the Option HDD
3) Fit the 2 bosses of the Connector Fixation Screw into the holes of the Conversion
Connector to install, and tighten the screws in the order specified below.
•
2 Screws (P Tightening; M3x8)
CAUTION:
•
•
F-9-277
9
Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Assembling the Option HDD
Be sure to firmly hold the Connector Fixation Block when tightening the screws.
Be sure to follow the correct order to tighten the screws, otherwise the Conversion
Connector may not be connected properly, resulting in poor contact.
x2
9-128
F-9-278
Boss
Hole
F-9-279
9-128