Canon imageRUNNER ADVANCE 8105 Series Service Manual page 898

■
TEMPO
COPIER > OPTION > TEMPO
F-POT-SW [Not used]
Lv.2 Details -
F-HUM-SW ON/OFF of humidity manual entry
Lv.2 Details To set whether to enable F-HUM-D setting when an error (failure) in
the Environment Sensor occurs.
When 1 is set, the F-HUM-D setting is enabled. Use the item as a
temporary measure until replacing the Environment Sensor.
Use case When an error (failure) in the Environment Sensor occurs
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 0
Related service mode COPIER> OPTION> TEMPO> F-HUM-D
F-HUM-D Manual entry of humidity
Lv.2 Details Enter the humidity at the installation location manually when an error
in the Environment Sensor occurs.
When F-HUM-SW is 1, this setting is enabled.
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 30 to 99
Unit 1%
Default value 35
Related service mode COPIER>OPTION>TEMPO>F-HUM-SW
8
Service Mode > COPIER > OPTION > LCNS-TR
T-8-73
8
Service Mode > COPIER > OPTION > LCNS-TR
■
LCNS-TR
COPIER > OPTION >LCNS-TR
ST-SEND Installation state dis of SEND function
Lv.2 Details To display installation state of SEND function when transfer is
disabled.
Use case When checking whether SEND function is installed
Adj/set/operate method 1) Select ST-SEND.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is
displayed under TR-SEND.
When operation finished normally: OK!
Display/adj/set range
Default value 0
TR-SEND Trns license key dis of SEND function
Lv.2 Details To display transfer license key to use SEND function when transfer is
disabled.
Use case - When replacing HDD
- When replacing the device
Adj/set/operate method 1) Select ST-SEND.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-SEND.
Display/adj/set range 24 digits
ST-ENPDF Installation state dis of Encryption PDF
Lv.2 Details To display installation state of Encryption PDF when transfer is
disabled.
Use case When checking whether Encryption PDF is installed
Adj/set/operate method 1) Select ST-ENPDF.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is
displayed under TR-ENPDF.
When operation finished normally: OK!
Display/adj/set range
Default value 0
TR-ENPDF Trns license key dis of Encryption PDF
Lv.2 Details To display transfer license key to use Encryption PDF when transfer
is disabled.
Use case - When replacing HDD
- When replacing the device
Adj/set/operate method 1) Select ST-ENPDF.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-ENPDF.
Caution This mode is enabled when SEND function is installed.
Display/adj/set range 24 digits
8-183
8-183