Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1052

5) Insert the Main Controller PCB 1 until it stops.
6) Connect the USB Cable and the Control Panel Cable.
7) Install the Side Cover.
■
Installing the Expansion Bus-F1, the Wireless LAN Board-B1
and the IPSec Board-B2 Simultaneously
CAUTION: Point to Note at Installation
Be careful to install the correct Wireless LAN Support Plate.
CAUTION: Point to Note at Installation
When installing the Bulkhead Unit, be sure to place the flat side of the terminal at upper
side.
9
Installation > Installation Procedure for Expansion Bus-F1, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Installing the Expan
1) Install the Bulkhead Unit to the Wireless LAN Support Plate.
• 2 Screws (TP; M3x6) (Included in the Wireless LAN Board)
2) Install the Expansion PCB (included in the Expansion Bus Kit) to the Expansion Support
Plate.
• 2 Screws (TP; M3x6) (Included in the Expansion Bus Kit)
CAUTION: Point to Note at Installation
When installing the Expansion PCB, be sure to place it under [A] part of the Expansion
F-9-207 F-9-207
Support Plate.
9
Installation > Installation Procedure for Expansion Bus-F1, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Installing the Expan
x2
Wireless LAN Support Plate Bulk Head Unit
Expansion PCB
x2
Expansion Support Plate
9-90
F-9-208 F-9-208
[A]
F-9-209 F-9-209
9-90