Canon imageRUNNER ADVANCE 8105 Series Service Manual page 414

4
Parts Replacement and Clearning > Image Formation System > Removing the Drum Cleaning Blade
2) Remove the Drum Cleaning Blade.
•
5 Screws (to loosen)
Loosen
Note: Points to Note when Installing the Drum Cleaning Blade
Be sure to apply toner on the contact area (edge) on the Drum of the Drum Cleaning
Blade. In particular, be sure to apply toner on both edges of the Blade.
4
Parts Replacement and Clearning > Image Formation System > Removing the Drum Cleaning Blade
F-4-148
Note: Points to Note when Installing the Drum Cleaning Blade Unit
1. Wipe out the toner on both edges of the Drum Cleaning Unit before installation.
2. Be sure to fit in the center position, and then temporarily tighten the screws following
the numeric order (from 1 to 4) and also securely tighten the screws (from 5 to 9).
x5
4-118
F-4-149
4-118